Table of Contents
Advertisement
Troubleshooting:
The XTP series light head has been thoroughly factory tested. If any of the the device functions fail, please check the following:
1. Be sure the power source is activated, then check all connections both positive and ground at the light head (to assure no open or shorted
circuits).
2. Permanently connecting the Blue programming wire to ground will disable the light head, no matter what the programmed flash pattern.
3. If the Dim function does not operate, verify the Blue wire is connect to positive.
4. If the sync function is not being used and the light head is functioning erratically, verify the Yellow wire is not connected to positive.
Page 5 of 8
Advertisement
Table of Contents
Need help?
Do you have a question about the XTP Series and is the answer not in the manual?
Questions and answers