Glass Gobo Orientation - SHOWTEC Phantom 3R Hybrid V1 Manual

Phantom 3R Hybrid
03) Remove the lamp cover by unscrewing the 4 screws (see fig. 12).
04) Gently tilt the head so that the small metal housing can slide out more easily.
05) Turn the gobo wheel, with the gobo you want to remove, to the upside.
06) Gently lift up the gobo holder by 10º and then gently pull out the gobo from its position.
07) Very carefully take the gobo out of the gobo holder with a pair of pliers.
08) Place the new gobo in the gobo holder. Carefully put the pinchcock back. You can use a pair of
pliers to press the pinchcock a little bit together.
09) Put the gobo holder back under the pressing snap and push it back.
10) Replace the maintenance caps and fasten all screws.

Glass Gobo Orientation

Coated glass gobos are inserted with the coating against the rim of the holder (away from the spring).
Textured gobos are inserted with the smooth side against the spring. This provides the best results when
combining rotating gobos.
When an object is held up to the coated side
there is no space between the object and its
reflection. The back edge of the gobo cannot
be seen when looking through the coated side.
Ordercode: 40074
When an object is held up to the uncoated side
there is a space between the object and its
reflection. The back edge of the gobo can be
seen when looking through the uncoated side.
28
Fig. 12
Fig. 13