Lamp Settings; Maintenance - SHOWTEC Phantom 3R Hybrid V1 Manual

Phantom 3R Hybrid

1. Lamp Settings

01) If you have chosen LAMP SETTINGS (in step 4, page 17), the display will show:
02) Press the UP/DOWN buttons to toggle between the following options:
 On/Off (switch the lamp on and off, ON/OFF)
 State/Power on (define whether the lamp is on or off upon start-up, ON/OFF)
 Off via DMX (adjust the dimmer via DMX, YES/NO)
 On if DMX on (if the device receives DMX, the lamp will be on; YES/NO)
Off if DMX off (if the device does not receive DMX, the lamp will be off; YES/NO)

 Ignition delay (define the number of seconds which need to pass after start-up before the lamp
turns on, 0-255)
 Low power delay (define the number of seconds which need to pass after start-up before the
device calibrates its gobos and pan/tilt motors, 0-255)
 Reset lamp time
03) Press the ENTER button to edit the desired option.
04) Press the UP/DOWN buttons to set the value.
05) Press the ENTER button to save changes.

2. Maintenance

01) If you have chosen MAINTENANCE (in step 4, page 17), the display will show:
02) Press the UP/DOWN buttons to toggle between the following options:
 Interval Time (define the number of hours after which the device should undergo a safety check,
10-250)
 Remain Time (reset the internal maintenance clock after each safety check, NO/RESET)
03) Press the ENTER button to edit the desired option.
04) Press the UP/DOWN buttons to set the value.
05) Press the ENTER button to save changes.
Ordercode: 40074
18