Advertisement
ADuCM322 Getting Started Guide
GETTING STARTED
SOFTWARE INSTALLATION PROCEDURES
Perform the steps described in this section before plugging any
of the USB devices into the PC.
1.
Close all open applications.
2.
Insert the installation DVD into a DVD drive.
3.
Double-click ADuCM310_32x.exe and follow the on-screen
instructions. A menu displays installation options as shown
in Figure 2.
Figure 2. Installation Options
The following components install by default:
FTDI drivers for the evaluation board.
Example code and function sets for most peripherals.
An Elves.exe application to easily choose functions from
the provided function sets followed by choosing from the
function parameters.
The following components are optional installations:
Keil development tools (a compiler, debugger, and
programming tools). The Keil software Revision v5.14 is
used. Analog Devices added a patch to this revision of the
MDK460 tools to support the ADuCM322.
IAR development tools (a compiler, debugger, and
programming tools).
Segger J-Link drivers. These are the drivers for the J-Link
emulator.
The J-Link software is selected by default in the installation menu
shown in Figure 2. It is advised to leave it selected. The J-Link
software automatically installs the J-Link serial port driver. Select
Install USB Driver for J-Link-OB with CDC as shown in Figure 3.
If that step is missed, run JLinkCDCInstaller_V1.2b.exe
located in the ADuCM322\Segger folder.
If using the IAR tools, the entire contents of the supplied arm
directory (for example, C:\ADuCM322...\IAR\IAR_M320_
Patch0.2.zip\arm) must be copied to the IAR tools directory
(for example, C:\Program Files\IAR Systems\ Embedded
Workbench 6.5 Kickstart\arm).
Future updates may be available from the Analog Devices
FTP
site.
KEIL μVISION5
The Kiel μVision5 integrated development environment (IDE)
integrates all the tools necessary to edit, assemble, and debug
code. The fastest way to get started is to open an existing Kiel
μVision5 project by following these steps:
1.
In Keil μVision5, select Project > Open Project.
2.
Browse to the folder where the
installed (such as, C:\ADuCM322...).
3.
Open the file DIO.uvproj in the folder
code\ADuCM322\examples\DIO. This file launches an
example project.
4.
Compile and download to the device.
5.
To run the example code, press RESET on the board or
enter debug mode and select Run.
6.
When running, the red LED marked DISPLAY on the
board flashes.
Rev. 0 | Page 3 of 5
Figure 3. Installing Link Software
ADuCM322
UG-910
software is
Advertisement
