ATTO Technology FastStream SC 5550 Installation And Operation Manual page 68

Partition
Partition sets the specified partition to the specifed capacity in
gigabytes (GB), megabytes (MB), or blocks. The specified
capacity must be smaller than the specified partition's current
capacity. A new partition is created to acquire the remainder of
the original partition's space.
Partition [GroupName] [PartIdx] [capacity] [GB | MB |
blocks]
PartitionDisplay
PartitionDisplay outputs a list of all of the partitions available in
the specified RAID Group. The partitions are listed in order of
contiguousness (as opposed to index order). GroupName is the
ASCII name of the RAID Group for which partitions will be
displayed.
PartitionDisplay <GroupName>
PartitionMerge
PartitionMerge merges the specified contiguous partitions into
one partition. GroupName is the ASCII name of the RAID
Group containing the partitions to merge. PartIdx is the index of
a partition to merge, along with a number of contiguous
partitions to merge to that index. 'All' indicates that all partitions
in the RAID Group will be merged into a single Virtual Disk. The
RAID Group must not be in a NEW state. None of the partitions
to merge may be mapped.
PartitionMerge [GroupName] [[[PartIdx] [2-128]] | all]
PartitionSplit
PartitionSplit splits the specified partition into one or more
partitions whose capacities are evenly distributed among the
capacity of the original partition. GroupName is the ASCII name
of the RAID Group containing the partition to split. PartIdx is the
index of the partition to split. The partition to split cannot be
mapped. The RAID Group must not be in a NEW state.
PartitionSplit [GroupName] [PartIdx] [2-128]
PartitionWriteCache
Enable RAID internal Write Cache for higher write performance
with a small risk of data loss after a system failure. Disable
RAID internal Write Cache for a higher level of data integrity with
lower write performance.
set PartitionWriteCache [GroupName] [PartIdx] [enabled
| disabled]
get PartitionWriteCache [[GroupName] [PartIdx] | all]
PassThroughMode
PassThroughMode specifies the non-disk device types which
will be automatically mapped at boot time. The "all" option
allows all non-disk devices to be mapped. The "SES" option
allows dedicated SES processor LUNs to be mapped. The "non-
SES" option allows all non-SES devices to be mapped. The
"disabled" option disables the pass-through mode.
set PassThroughMode [all | SES | non-SES | disabled]
get PassThroughMode
PassThroughPersistent
PassThroughPersistent stores maps for currently-attached
passthrough devices to persistent memory.
PassThroughPersistent
PassThroughRediscover
PassThroughRediscover will make any previously deleted pass
through target devices visible to the host
PassThroughRediscover
Password
Password specifies the password used for all sessions: Telnet,
FTP and Webserver. Password is case sensitive, 0 to 32
characters, and cannot contain spaces. An empty password
can be configured by pressing the enter key when prompted for
the new password and new password confirmation.
set Password
Performance
(all but SC 8250)
Returns the performance data for the user-specified Fibre
Channel port. Data consists of the average rate (MB/s) and
number of I/Os (IO/s) measured over the previous sampling
period (approximately one second). Successful SCSI Read
(08h, 28h) and Write (0Ah, 2Ah) commands are considered
I/Os. Factors that may affect reported performance include
Fibre Channel port availability and saturation, target device
speeds, and overall system utilization.
get Performance <fp>
Ping
Ping will send an ICMP echo request to the specified host.
Ping [mp1] [[xxx.xxx.xxx.xxx] | [IPv6-compatible address]]
<count <size>>
xviii