ATTO Technology FastStream SC 5550 Installation And Operation Manual page 65

DumpEventLog
DumpEventLog can be used to dump the entire contents of the
event log to an available RS-232 or telnet session.
DumpEventLog
EmailFromAddress
EmailFromAddress configures the email address that this
system will use to talk to the email server. Full email address is
a fully qualified Internet email address, not more than 128
characters long.
set EmailFromAddress [full email address]
get EmailFromAddress
EmailNotify
EmailNotify turns on and off email notification. Default is
disabled.
Default: Disabled
set EmailNotify [enabled | disabled]
get EmailNotify
EmailNotifyAddress
EmailNotifyAddress configures notification addresses. Index is
a number between 1 and 5, inclusive. Full email address is a
fully qualified Internet email address, not more than 128
characters long. The level can be "all", "informational",
"warning", "critical" or "none". This is the minimum level of
severity in order for the event to trigger an email notification.
set EmailNotifyAddress [index] [full email address]
[warning level]
get EmailNotifyAddress <index | All>
EmailPassword
EmailPassword sets the password used to authenticate the
login to the SMTP email server. The password must not be more
than 64 characters. A password is not required if the email
server does not require authentication.
set EmailPassword
EmailServerAddress
EmailServerAddress configures the address of the server that
should be contacted in order to send out emails. Either an IP
address or a fully qualified domain (e.g. mail.myserver.com)
may be specified.
Default: 0.0.0.0
set EmailServerAddress [xxx.xxx.xxx.xxx | name]
get EmailServerAddress
xv
ATTO Technology Inc. FastStream SC Installation and Operation Manual
EmailUsername
EmailUsername sets the username used to authenticate the
login to the SMTP email server. The username must not be
more than 128 characters. A username is not required if the
email server does not require authentication.
set EmailUsername [username]
get EmailUsername
EthernetSpeed
EthernetSpeed determines the speed of any Ethernet port(s). If
Auto is enabled then the Ethernet speed will be negotiated and
the value in parentheses returned by the 'get' command
indicates the current speed of the Ethernet connection. When
hard set, 10 and 100 speeds are half duplex.
Default: mp1 auto
set EthernetSpeed [mp1] [10 | 100 | 1000 | auto]
get EthernetSpeed [mp1]
EventLog
EventLog can be used to enable/disable the event logging
feature. When enabled, various system events are recorded to
the event log.
set EventLog [enabled | disabled]
get EventLog
EventLogFilter
EventLogFilter is used to filter data from specific subsystems
and levels while event logging is enabled.
Default: all all all
set EventLogFilter [subsys | all] [event level | all] [all |
none]
get EventLogFilter [subsys | all] [event level | all]
Exit
Exit terminates the current CLI session over Telnet. This
command has no effect if used during a serial RS-232 session.
Exit
FCConnMode
(all but SC 8250)
FCConnMode specifies the connection mode used when
communicating across a Fibre Channel network. The system
will connect to an arbitrated loop (FC_AL) if 'loop' is selected.
The system will connect in point-to-point mode if 'ptp' is
selected. The options of 'loop-ptp' (AL Preferred) and 'ptp-loop'
(PTP Preferred) allow auto-negotiation while indicating a
preference.
Default: loop
set FCConnMode [fp | all] [loop | ptp | loop-ptp | ptp-loop]
get FCConnMode [fp | all]