Faststream Sc 5550 Physical Attributes; Dimensions; Cooling And Airflow; Power - ATTO Technology FastStream SC 5550 Installation And Operation Manual

1.1 FastStream SC 5550 Physical Attributes

The ATTO FastStream SC 5550 is a Fibre Channel to SAS/SATA RAID storage controller which can be
seamlessly integrated into a new or an existing storage environment.
The ATTO FastStream SC 5550 is available in a
desktop model, an industry-standard 1U form factor
for easy integration into racks and as an embeddable
board-level product.
For installation instructions for the desktop and 1U
models, refer to Install the FastStream
For installation instructions and physical attribute
details for the embeddable model, refer to the ATTO
Embedded Storage Controller Installation and
Operation manual.

Dimensions

Width: 17.31 inches
Length: 9.9 inches
Height: 1.69 inches (1U)
Weight: approximately 8 pounds

Cooling and airflow

Operating Temperature: 5 °C-40 °C
Humidity: 10-90% non-condensing
CAUTION CAUTION
Do not block the enclosure's vents. The
FastStream does not allow data transfer if
overheating occurs. Ambient air should
not exceed 40 °C.

Power

Input voltage: 100-240 VAC, 1A, 47-63 Hz
Battery-backed event log: A rechargeable Lithium
ion battery cell holds the event log memory for up to 30
days. If the FastStream has been disconnected from
power, recharging begins automatically when power is
restored to the system. The battery is fully charged
after 36 hours of continuous power application.
WARNING
WARNING
Risk of explosion if battery is removed
and/or replaced by an incorrect type.
Dispose of used batteries in accordance
with your local environmental regulations.
Explosionsgefahr, wenn die Batterie falsch
entfernt und/oder ersetzt wird. Entsorgen
4
ATTO Technology Inc. FastStream SC Installation and Operation Manual
Sie benutzte Batterien in Übereinstimmung
mit Ihren lokalen
Umweltschutzbestimmungen.
Fibre Channel ports
The two independent 4Gb/s Fibre Channel ports
on page 10.
connect the FastStream SC 5550 to Fibre Channel
hosts using optical SFP connectors and multimode
fiber optic cable.
Make sure all cables are anchored securely at both
ends with the proper connectors.
SAS/SATA connectors
The two (x4) 3Gb/s SAS/SATA
connectors connect storage
devices into the Storage Area
Network (SAN) using mini SAS
4x cable plug connectors.
Management ports
Management is provided using the 10/100/1000 base
T Ethernet port accessible from the RJ-45 connector
or the RS-232 serial port using an RJ-11 connector.
(See Exhibit 1.1-1
Reset/restore factory default switch
To reset the FastStream, briefly insert a tool in the
reset hole in the back panel for less than three
seconds. See
To restore factory defaults, insert a tool in the reset
hole in the back panel for more than four seconds until
the green Ready LED blinks.
LED indicators
The LED indicators can be viewed from the connector
side and the front side of the FastStream. (See
Exhibit 1.1-2
LEDs on the connector side are:
Ready/Fault LED lights green to indicate ready, lights
yellow to show a faulted condition, and is off to indicate
not ready.
Ethernet port connector: The right green LED
shows a valid link, off indicates that no link is present,
and blinking indicates activity. The left green LED
indicates 10/100/1000 MbE speed: on indicates
100/1000 MbE and off indicates 10 MbE.
on page 5).
Exhibit 1.1-1 on page 5.
on page 5 and Exhibit 1.1-3 on page 5)