ATTO Technology FastStream SC 5550 Installation And Operation Manual page 67

Info
Info displays version numbers and other product information for
key components. Use the optional 'brief' parameter to show a
more concise subset of system information.
Info <brief>
IPAddress
IPAddress controls the current IP address of any Ethernet
port(s). If IPDHCP is enabled, then the 'get' command reports
the current IP address assigned by the network DHCP server,
followed by the (DHCP) identifier.
set IPAddress [mp1] [[xxx.xxx.xxx.xxx] | [[IPv6-
compatible address] [Prefix length]]]
get IPAddress [mp1]
IPDHCP
IPDHCP allows acquisition of an IP address from a network
DHCP server. When this option is disabled, the IP address used
will be specified by the IPAddress CLI command.
set IPDHCP [mp1] [enabled | disabled]
get IPDHCP [mp1]
IPDNSServer
DNSServer controls the current DNS Server address. If
IPDHCP is enabled, then this value is automatically detected. If
IPDHCP is disabled, then this value must be manually set.
set IPDNSServer [xxx.xxx.xxx.xxx]
get IPDNSServer
IPGateway
IPGateway controls the current default gateways used by any
Ethernet port(s). If IPDHCP is enabled, then the 'get' command
reports the current IP gateway assigned by the network DHCP
server.
set IPGateway [mp1] [xxx.xxx.xxx.xxx]
get IPGateway [mp1]
IPSubnetMask
IPSubnetMask controls the current subnet masks used by any
Ethernet port(s). If IPDHCP is enabled, then the 'get' command
reports the current IP subnet mask assigned by the network
DHCP server.
set IPSubnetMask [mp1] [xxx.xxx.xxx.xxx]
get IPSubnetMask [mp1]
IPV6Gateway
IPV6Gateway controls the current default gateway used by the
IPv6 protocol. Unlike the IPGateway command, there is only 1
IPV6Gateway allowed.
set IPV6Gateway [IPv6-compatible address]
get IPV6Gateway
xvii
ATTO Technology Inc. FastStream SC Installation and Operation Manual
IPV6RemoveAddress
IPV6RemoveAddress removes the manually configured IPv6
network address from the given network interface if that
interface has been manually configured.
IPV6RemoveAddress [mp[n]]
IsReserved
IsReserved displays the reservation status of the current
services session/interface.
IsReserved
MaxOpTemp
MaxOpTemp sets/displays the maximum operating temperature
in degrees Celsius. Valid entries are between 55 and 70
degrees.
set MaxOpTemp [55 - 70]
get MaxOpTemp
MediaScanErrorReport
Displays media scan error statistics for either a single block
device or all block devices in the system.
MediaScanErrorReport [BlockDevID | all]
Metrics
The Metrics CLI command offers control over the collection of
standard data metrics within a product via the command's
'Start', 'Stop', and 'Display' parameters.
Metrics [Start|Stop|Display|Clear] [[drive
[BlockDevID]]|all|running]
MinOpTemp
MinOpTemp sets/displays the minimum operating temperature
in degrees Celsius. Valid entries are between 0 and 15 degrees.
set MinOpTemp [0 - 15]
get MinOpTemp
OEMConfigFile
This command returns the "name" (i.e., the contents of the first
record) of the OEM configuration file stored in persistent
memory.
get OEMConfigFile
OpTempWarn
OpTempWarn sets/displays the offset in degrees Celsius when
a warning will be issued prior to a thermal control event. Valid
entries are between 0 and 15 degrees.
set OpTempWarn [0 - 15]
get OpTempWarn