Working With The Mortising Unit (Optional) - HOLZMANN MASCHINEN HOB 410PRO User Manual

13.6

Working with the mortising unit (optional)

• Remove the cover (A) form the chuck of the planer
shaft.
• Clamp the required milling tool in the chuck.
• Lay up the workpiece on the mortising table.
• Tilt the downholder (B) to the middle of the
workpiece.
• Pull down the lever of the downholder to clamp the
workpiece.
• Adjust the table height with the hand wheel (C) to
the requested height of the milling tool.
• Adjust the horizontal travel range of the table with
the setting rings (D).
• To start the machine push start button (I).
• Move the table horizontally with the lever (E).
• After the working process stop the machine by
pushing the stop button (G).
• Before further activities wait until blade shaft is at a
standstill!
13.7 After working process
•
•
•
HOLZMANN MASCHINEN GmbH
After the working process the machine must be turned off:
Push stop button at the switch unit.
Disconnect the plug from the switch unit so the machine is disconnected from the
power supply.
Adjust the blade so that the planer shaft is completely covered.
www.holzmann-maschinen.at
D
H I N W E I S
A
HOB 410PRO
37