Bevelling Of Edges; Planing On Frame; After Working Process; Cleaning, Maintenance, Storage, Disposal Cleaning - HOLZMANN MASCHINEN EHH110 Operating Manual

13.3.3 Bevelling of edges

13.3.4 Planing on frame

13.4

After working process

After the working process the machine must be turned off:
• Switch off the machine
• Do not lay down the machine until the planer shaft has come to a standstill.
(avoidance of damage to the workpiece and the planing knife)
• disconnect the plug so the machine is disconnected from the power supply
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
14.1 Cleaning
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil.
Regular cleaning is a prerequisite for a safe operation of the machine and its long lifetime.
Therefore, clean the machine after each use, at least once a week.
HOLZMANN MASCHINEN GmbH
To make a bevel cut as shown in the illustration,
align the "V" groove in the front edge with the edge
of the workpiece and plane it.
1. Modify to frame-setup
2. First place the workpiece on the pick-up table
3. Switch on the machine and wait until the planing
4. then carefully move the workpiece forwards.
N O T I C E
N O T E
www.holzmann-maschinen.at
(adjustable table) without the planing knives
coming into contact.
shaft has reached full speed.
W A R N I N G
Danger of contact with planing shaft:
Only workpieces with sufficient dimensions
(width >110mm) and a thickness > 50mm
are allowed to be machined. The workpiece
may only be guided with a flat hand.
24
EHH110