Table of Contents
Advertisement
Available languages
Available languages
12.1.2
Workplace requirements
Choose a suitable place for the machine. Observe the safety requirements and the dimensions of
the machine.
The selected location must ensure as well as the possibility for connection to an extraction system
a suitable connection to the electrical grid.
Make sure that the floor can support the weight of the machine. The machine must be levelled on
all bases simultaneously.
You must also secure around a distance of at least 0.8 m around the machine. Before and behind
the machine must be provided the necessary distance for the supply of long workpieces.
12.1.3
Transport
The lifting and transportation of the machine must only be carried out by qualified
staff and must be carried out with appropriate equipment.
Note that lifting devices possible used (crane, forklift, sling etc.)
must be in perfect condition.
To transport the machine in the packaging to the workplace is best
to use a forklift truck (D) or lifting device (E).
In the workplace, remove the packaging and lift the machine to the
workplace.
While lifting the machine, make sure that not third parties may be
in the danger zone!
The machine must be lifted only with correspondingly suitable
lifting devices from the packaging.
Prepare to a forklift truck (D) or a lifting device (E) before, this and
the hoisting ropes should min. be approved for the weight of the
machine.
Put the four hooks in the provided openings in the machine.
Lift the machine slightly and check that the load distribution
is stable.
12.1.4
Preparation of the surface
Do not use solvents based on nitrite, aggressive solvents like break cleaners or
scrubbing agents!
These damage the machine surface.
12.2
Power supply
When working with non-grounded machines:
Severe injury or even death may arise though electrocution!
Therefore: The machine must be operated at a grounded power socket
The connection of the machine to the electric power supply and the following checks have to be
carried out by a respectively trained electrician only.
1. The electronic connection of the machine is designated for operation with a grounded power
socket!
2. The mains supply must be secured with 16A:
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
W A R N I N G
N O T I C E
A T T E N T I O N
29
HOB 410PRO
Advertisement
Table of Contents
