Wiring - Furuno MU-192HD Operator's Manual

1. MOUNTING, WIRING
1.7

Wiring

Refer to figure below and the interconnection diagram at the back of this manual to connect ca-
bles.
Connector
MJ-A3SPF0017-050ZC MJ-A3SPF0017-050ZC
(5 m, standard supply) (5 m, standard supply)
12-24 VDC
1
* : Slide switch
Referring to below table to set the slide switch according to your vessel's configuration.
Slide Switch Inputs
ON (Factory de- Digital input
fault) (DVI, HDMI)
OFF Analog input
(RGB)
Note: Turn the slide switch off when you connect equipment to both the DVI, HDMI and RGB
ports.
2
* : BRILL CTRL port
Remove the sticker from the BRILL CTRL port, then connect the USB cable.
The bottom of the rear of the display unit
RGB signal RGB signal
3COX-2P-6C 3COX-2P-6C
5 m/10 m (option) 5 m/10 m (option)
Slide switch Slide switch
CSH-5LMK2
IV-1.25 sq IV-1.25 sq
CSH-8LMK2
(local supply) (local supply)
NOTE:
To ground
Attach a crimp-on lug (inner dia. ø 4) for display unit side.
terminal on hull
Connect the ground cable as short as possible.
CAUTION
If the power is 24 VDC, replace the 10 A
fuse with the 5 A fuse (supplied). And
then attach the fuse label on the fuse
cover.
Connected devices
• Radar
• Plotter
• Fish finder
• Scanning sonar
• Current indicator
Digital signal Digital signal
DVI-D/D S-LINK DVI-D/D S-LINK
5 m/10 m (option) 5 m/10 m (option)
HDMI Cable HDMI Cable
(Local supply) (Local supply)
*1 *1
FAR-15X8,
FCV-38,
GD-300,
CH-500/600
FCV-1900
17
Composite Composite
signal signal
cable cable
USB Cable USB Cable
(local supply) (local supply)
BRILL CTRL port*
Upward: Default setting Upward: Default setting
(Slide switch ON) (Slide switch ON)
Downward Downward
(Slide switch OFF) (Slide switch OFF)
2