Table of Contents
Advertisement
Figure 32. Removing the 3.5-inch storage drive from the bracket
5. To install a new 3.5-inch storage drive, flex both sides of the bracket and align pins
with the corresponding holes in the new drive.
Notes:
• Ensure that the circuit board faces downward and the connectors face toward the rear of the bracket.
• Do not touch the circuit board on the storage drive during operation.
Figure 33. Installing the 3.5-inch storage drive into the bracket
6. Slide the bracket with the new 3.5-inch storage drive into the front-access storage enclosure until it
snaps into position. Press the notch to secure the enclosure cover and lock the enclosure cover with the
key.
Figure 34. Installing the 3.5-inch storage drive into the front-access storage enclosure
1
on the bracket
.
Chapter 7
Hardware removal and installation
71
Advertisement
Table of Contents
