Secondary Hard Disk Drive - Lenovo 30BH User Manual

Figure 75. Installing the primary hard disk drive
8. Connect the signal cable and the power cable to the new hard disk drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 100.

Secondary hard disk drive

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page iii.
Note: Your computer comes with a secondary storage drive bay for installing or replacing a secondary 3.5-
inch hard disk drive or a 2.5-inch solid-state drive.
To replace the secondary hard disk drive, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 57.
2. Locate the secondary hard disk drive. See "Computer components" on page 5.
3. Disconnect the signal cable and the power cable from the hard disk drive.
4. Pull the handle to release and remove the hard disk drive from the hard-disk-drive cage.
Figure 76. Removing the secondary hard disk drive
5. Flex the sides of the bracket to remove the hard disk drive from the bracket.
6. To install a new hard disk drive into the bracket, flex the bracket and align pin
on the bracket with the corresponding holes in the hard disk drive. Do not touch the circuit board
the bottom of the hard disk drive.
1 , pin 2
.
Chapter 7 Hardware removal and installation
, pin 3 , and pin 4
5 on
93