Lenovo 30BH User Manual page 108

Replacing the solid-state drive
To replace the solid-state drive, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 57.
2. Locate the desired storage drive bay. See "Internal storage drives" on page 7.
3. Disconnect the signal cable and power cable from the solid-state drive.
4. Remove the storage converter with the solid-state drive from the storage drive bay. See "Primary hard
disk drive" on page 91 or "Secondary hard disk drive" on page 93.
5. Flex the sides of the plastic 3.5-inch storage drive bracket to remove the storage converter from the
bracket.
Figure 81. Removing the storage converter from the 3.5-inch storage drive bracket
6. Remove the four screws that secure the solid-state drive. Then lift the solid-state drive out of the storage
converter.
Figure 82. Removing the solid-state drive from the storage converter
7. Install a new solid-state drive into the storage converter. Then install the four screws to secure the new
solid-state drive to the storage converter.
96
P320 User Guide