1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 57.
2. Locate the primary hard disk drive. See "Computer components" on page 5.
3. Disconnect the signal cable and the power cable from the hard disk drive.
4. Pull the handle to release and remove the hard disk drive from the drive cage.
Figure 73. Removing the primary hard disk drive
5. Flex the sides of the bracket to remove the hard disk drive from the bracket.
6. To install a new hard disk drive into the bracket, flex the bracket and align pin
on the bracket with the corresponding holes in the hard disk drive. Do not touch the circuit board
the bottom of the hard disk drive.
Figure 74. Installing the hard disk drive into the bracket
7. Slide the new hard disk drive into the drive cage until it snaps into position.
92
P320 User Guide
1
, pin
2
, pin
3
, and pin
5
on
4