Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
It is recommended that installation of the TrailSafe or TrailSafe+ is carried out by
a trained auto electrician.
Using the supplied mounting screw, mount the unit on the right-hand side of the
trailer's drawbar, about 300mm from the tow ball hitch.
The TrailSafe needs to be secured tightly to prevent it from vibrating loose.
Tighten the mounting screw to between 10-25Nm.
WARNING
Do not tighten the mounting screw to a torque higher than 30Nm.
The unit must be mounted horizontally on top or the side of the drawbar, with the
wires pointing towards the rear of the trailer (away from the tow vehicle) and the
pull pin facing the tow vehicle.
Only one mounting point is required for the unit to swivel in an emergency.
Attach the other end of the pull pin cord to the towing vehicle using a D-shackle
or similar.
9
Advertisement
Table of Contents
