Trailsafe Operational Use Without Swaycontrol - BMPRO TrailSafe Series Owner's Manual

TRAILSAFE OPERATIONAL USE WITHOUT SWAYCONTROL

Once the TrailSafe has finished calibrating and is ready for operational use, the
colour of the LED will change depending on the charge state of the battery.
NOTE: If you are using the TrailSafe+ alongside BMPRO's SwayControl, refer to
the TrailSafe+ Operational Use With SwayControl section of this manual.
COLOUR
The house battery capacity is sufficient for 15 minutes of emergency braking
operation.
The house battery may have insufficient capacity for 15 minutes of emergency
braking operation.
Check the battery to ensure at least 10Ah of house battery capacity is available.
The house battery is not detected or there is insufficient capacity for 15 minutes of
emergency braking operation.
Charge or replace the house battery.
STATE STATUS
Standby
mode
Brake pedal
depressed
For 1
minute
Pin out
Battery flat
Always on
Other
CONDITION
CONDITION
The TrailSafe is in standby as no brake activity has been detected
for 1 minute. The colour will change depending on the charge
state of the battery.
The colour will change depending on the charge state of the
battery.
A trailer breakaway has occured. The colour will change
depending on the charge state of the battery.
There is a TrailSafe breakaway
switch fault. The LED will flash
both orange and red.
The battery is flat.
The TrailSafe is in standby,
or there is no power, or the
voltage is less than:
9 10.5V for lead-acid
batteries
9 11.5V for Lithium batteries
19
SOLUTION
Do not use unit. Replace the
unit.
Charge or replace the house
battery.
If necessary, check the
TrailSafe by depressing the
brake.