Table of Contents
Advertisement
TRAILSAFE+ WITH SWAYCONTROL WIRING
INSTRUCTIONS
NOTE: This section applies to the TrailSafe+ when also using a SwayControl. If
you are using the TrailSafe without a SwayControl, refer to the TrailSafe Wiring
Instructions section.
The TrailSafe+ has multiple colored wires coming from the rear side which
require connection to ensure correct functionality. As this is a safety critical
system, all wiring should be done by a suitably qualified Auto Electrician.
Wire the TrailSafe+ to the house battery, trailer brakes and brake lights. Refer to
the TrailSafe+ With SwayControl Wiring Diagram.
WIRE
RED
(14AWG / 2.5mm2)
BLUE
(12 AWG/ 4 mm2)
PURPLE
(14 AWG/ 2.5 mm2)
WHITE
(14 AWG/ 2.5 mm2)
BLACK/RED
(12AWG / 4mm2)
GREEN
(20AWG / 0.5mm2)
YELLOW
(20AWG / 0.5mm2)
THIN RED
(20AWG / 0.5mm2)
CONNECTION
Connect to the positive of the brake lights.
Connect to the positive of the brakes.
Connect to a remote voltage monitor.
Connect to the negative of the house battery.
Connect to the positive of the house battery (30A fuse
required).
If using LiFePO4 Unconnected: connect to the positive
terminal of the house battery.
If using lead-acid: connect to the negative terminal of the
house battery.
If SwayControl is being used, connect to the
SwayControl via connector.
If SwayControl is not being used, leave unconnected.
If SwayControl is being used, to the
via connector.
If SwayControl is not being used, leave unconnected.
13
YELLOW
cable of
RED
cable of SwayControl
Advertisement
Table of Contents
