Using The Trailsafe; Initial Self-Test; In-Car Monitor - BMPRO TrailSafe Series Owner's Manual

USING THE TRAILSAFE

INITIAL SELF-TEST

1. Before starting, ensure the TrailSafe or TrailSafe+ pull pin is in place.
2. Power up the TrailSafe or TrailSafe+ from your 12V battery as per the wiring
instructions. The LED will display a continuous flashing PURPLE, indicating the
first stage of calibration is in progress. This will last for up to 5 minutes.
When the first stage is completed, the LED will display a solid PURPLE. When
3.
this happens, pull the safety pin out. The LED will display a continuous flashing
PURPLE
again, indicating the second stage of calibration is in progress. This will
last for up to 1 minute.
4. If the LED indicates an alternating PURPLE/RED, the wiring Voltage Drop in the
black/red wire (+v) and/or the white wire (-v) is exceeding 10% of the nominal
voltage. Check the wiring connections and consider increasing the black/red and/
or the white wire size.
5.
Once completed, LED will display a solid
pin back in. The LED will then display a status indicator. For details, refer to the
LED Status Indicators section of this manual.

IN-CAR MONITOR

If an in-car monitor is used, it needs to be located in a position where it is visible
to the driver.
If you are using BMPRO's TrailCheck, refer to the Wireless Monitor TrailCheck
manual for more details.
PURPLE
again. At this stage, put the pull
17