Table of Contents
Advertisement
CLEANING AND MAINTENANCE OF THE AIR CONDITIONER
Indoor Unit's cleaning
Before starting any kind of ordinary maintenance:
1 - Stop the appliance by pressing "ON/OFF" button on remote controller;
2 - Move the circuit breaker to "OFF" or "0" position;
3 - Pull the plug out of the power socket;
4 - To reach the Unit, please use a stepladder or other appropriate bearing strong enough to
ensure your safety.
Cleaning the remote controller
Do not use water, but a dry cloth. Do not use
products for glass cleaning, nor soaked in
detergents.
Never use any of the following products for cleaning
Benzine, paint solvents, polishing products,
by-products of oil in general, etc. may damage
the outside surfaces of Unit and cause
deformations and scratches on the appliance
and on the remote controller.
NOTES:
• If the appliance or the inlet grille are very dirty, clean them with a cloth soaked in tepid water and neutral
detergent. Rinse in clean watrer and dry well. The presency of humidity on the inlet grille may cause
electric shocks.
• Never use any abrasive sponge for cleaning, to avoid scratching the Unit's surfaces.
• If the grille is open or has been removed, do not touch the metallic flaps of the heat exchanger, as the
flaps are sharp and may hurt you.
• Do not expose the grille or the Unit to direct sunlight, to avoid discolouring or deforming them.
Outdoor Unit's cleaning
• Check regularly that the air inlet and outlet are not obstructed by dust or dirt in general.
• For any other cleaning or maintenance of Outdoor Unit, always contact the Authorized Technical
Service.
WARNING
Cleaning the Indoor Unit
Use a dry and soft cloth. In case of need,
dampen the cloth in water and neutral
detergent, then wring well.
The use of very hot water (over 40°C) may
discolour and/or deform the plastic parts.
-30-
Advertisement
Table of Contents
