Table of Contents
Advertisement
COOL, HEAT, FAN Modes
SET TEMPERATURE
AUTO
COOL
DRY
HEAT
ADJUST
4
ON/OFF
MO
DE
1
DIRECTION/
SLEEP
SWING
CLEAN
AIR
RESET LOCK
SELF
FOLLOW
CLEAN
ME
NOTES:
1.
In "FAN" mode, it is not possible to select your desired room temperature. Therefore, please move
directly from above item No. 1 to item No. 3.
2.
Operation in COOL, HEAT & FAN modes is memorized by the microcomputer, so if you would like
to keep it for next operation of the air conditioner, you only need to press "ON/OFF" button on remote
control. Set temperature and fan speed settings will be memorized too, so they will be the same at
next restart of the air conditioner.
3.
It is possible to change operation mode while the air conditioner is operating. However, the Unit will
not immediately start operating according to the new mode, but a little delay is needed for carrying
out a test and choosing new operating parameters.
HEAT, COOL, FAN OPERATION
(°C)
FAN
~
~
~
~
HIGH
MED
LOW
2
FAN SPEED
3
TIMER ON
TIMER OFF
LED
TURBO
DISPLAY
Connecting/operating the air conditioner
Connect the air conditioner to the power source: the
OPERATION" LED on Indoor Unit's panel will start
flashing.
1.
Select your desired operation mode by pressing
"MODE" button:
• COOL
• HEAT
• FAN
2.
Press "ADJUST" buttons to select your desired
temperature.
3.
Select your desired fan speed by pressing "FAN
SPEED" button:
- AUTO
- LOW
- MED
- HIGH
Press "ON/OFF" button to start the air conditioner:
4.
"OPERATION" LED on Indoor Unit's panel will
stop flashing and will light up.
In COOL & HEAT modes, operation starts after
approximately 3 minutes; if you select FAN
mode, the Unit will start immediately.
Stop
Press "ON/OFF" button on remote control to stop the
air conditioner's operation.
-17-
Advertisement
Table of Contents
