Table of Contents
Advertisement
XII. Care and maintenance
1) After each dive, soak the sealed flash in fresh water for about 15
minutes to remove any residual salt, sand and dirt. Never allow the
saltwater to dry on the flash.
2) Push the test button about 10 times and rotate dials to clean any
saltwater or sand trapped under the button.
3) Let the water drain out of the small holes located at the bottom of
flex arm. (If using Flex Arms - see page 29 for optional accessories).
4) Dry off the flash with a towel. Make sure you and the flash are dry
before opening the waterproof battery cap.
5) Remove battery before storing the flash.
6) Allow flash to thoroughly dry before storage.
7) Never use any detergents, cleaners, solvents or chemicals to clean
the flash.
8) Insert a fresh Moisture-Muncher capsule (item #SL911) inside the
battery compartment during storage to help keep the inside dry and
free of corrosion or mildew during storage.
9) Clean the gold-plated battery contacts regularly using a clean
cotton cloth moistened with isopropyl alcohol. Remove the batteries
before storing the flash.
(After your dive)
27
Advertisement
Table of Contents
