Care And Maintenance - Sealife Sea Dragon flash Instruction Manual

X. Care and maintenance
1) After each dive, soak the sealed flash in fresh water for about
15 minutes to remove any residual salt, sand and dirt. Never
allow the saltwater to dry on the flash.
2) Push the test button about 10 times and rotate dials to clean
any saltwater or sand trapped under the button.
3) Let the water drain out of the small holes located at the bottom
of flex arm. (If using Flex Arms - see page 26 for optional
accessories).
4) Dry off the flash with a towel. Make sure you and the flash are
dry before opening the waterproof battery cap.
5) Remove battery before storing the flash.
6) Allow flash to thoroughly dry before storage.
7) Never use any detergents, cleaners, solvents or chemicals to
clean the flash.
8) Insert a fresh Moisture-Muncher capsule (item #SL911) inside
the battery compartment during storage to help keep the inside
dry and free of corrosion or mildew during storage.
24
(After your dive)