Table of Contents
Advertisement
VII. Test the camera and flash [above water]
Now that you have made all the correct settings to your flash and
camera, take a few test pictures to make sure the camera and external
flash fires together.
1. Power on the camera and flash.
a. Make sure the camera settings are set as described on page
16-17.
b. Turn the flash brightness control dial on the back of the flash
to Auto.
2. Wait for the flash-ready light to turn on. A blinking flash-ready
light means the flash is recycling, which takes a few seconds.
3. Take a series of test picture while viewing the external flash from
the side (Don't look directly into the flash).
4. The camera's flash and the external flash should be firing together.
5. If the external flash is not firing at the same time as the camera's
primary flash review the instructions on pages 6 through 17 or
refer to the trouble shooting guide at the end of this manual.
18
Advertisement
Table of Contents
