Table of Contents
Advertisement
XI. Maintaining a waterproof seal
1) The flash uses two O-rings to maintain a waterproof seal.
2) Every time you open the battery cap make sure the O-rings and
sealing surfaces are clean, undamaged and lubricated.
3) Dampen a clean cotton cloth and wipe it around the o-ring and
o-ring contact surfaces to remove any hair, sand or debris.
4) Carefully inspect the o-ring for cuts, tears or other damage. Replace
o-rings if damaged.
5) Lube O-rings regularly. Apply a small amount of silicone lube on your
finger tip and wipe it around the O-rings. Wipe off excess lubricant.
The o-ring surface should have shiny, wet appearance.
Important:
Replace O-rings every year if damaged or not. Visit your local SeaLife dealer or
www.sealife-cameras.com for information on ordering spare o-rings.
26
(Before your dive)
Advertisement
Table of Contents
