Hitachi Koki G 23MR Handling Instructions Manual page 9

English
CAUTION
Repair, m odification and inspection of Hitachi Pow er
Tools m ust be carried out by a Hitachi Authorized
Service Center.
This Parts List w ill be helpful if presented w ith the
tool to the Hitachi Authorized Service Center w hen
requesting repair or other m aintenance.
In the operation and m aintenance of pow er tools,
the safety regulations and standards prescribed in
each country m ust be observed.
M ODIFICATIONS
Hitachi Pow er Tools are constantly being im proved
and m odified to incorporate the latest technological
advancem ents.
Accordingly, som e parts (i.e. code num bers and/or
design) m ay be changed w ithout prior notice.
NOTE
Due to HITACHI's continuing program of research and
developm ent, the specifications herein are subject to
change w ithout prior notice.
Information concerning airborne noise and vibration
The m easured values w ere determ ined according to
EN50144.
The typical A-w eighted sound pressure level: 90 dB (A)
The typical A-w eighted sound pow er level: 103 dB (A)
Wear ear protection.
The typical w eighted root m ean square acceleration
value does not exceed 2.5 m /s
Information about pow er supply system of nominal
voltage 230 V~ (For G18M R, G23M R only)
Under unfavorable m ains conditions, this pow er tool m ay
cause transient voltage drops or interfering voltage
fluctuations .
This pow er tool is intended for the connection to a pow er
supply system w ith a m axim um perm issible system
im pedance Z of 0.23 Ohm at the interface point (pow er
M AX
service box) of the user's supply.
The user has to ensure that this pow er tool is connected
only to a pow er supply system w hich fulfills the
requirem ent above.
If necessary, the user can ask the public pow er supply
com pany for the system im pedance at the interface
point.
8
.
2