Table of Contents
Advertisement
FTK01 & FMC2105-SU
FTTR Fiber Termination Kit & Field Mountable Connector
Quick Installation Guide
Step 2 Rotate the shaft to close the coating stripper. Hold the shaft end (edge side) of the coating
stripper with one hand and horizontally pull out the optical cable with the other hand to strip
off the coating.
Do not exert excessive force when holding the shaft end (edge side) of the stripper.
Step 3 After confirming that the fiber is intact, clean the stripped fiber using alcohol.
Gently press the upper and lower, left and right sides with your fingers to 60 degrees, three times in each
direction to confirm that there are no fiber cracks.
Step 4 Rotate the optical cable fastener. For 1.2 mm x 1.6 mm optical cables, select the 1.2 mm
channel. For 2 mm x 1.6 mm and 2 mm x 3 mm optical cables, select the 2.0 mm channel.
The narrow channel of the optical cable fixing piece is applicable to 1.2 mm x 1.6 mm optical
cables, and the wide channel is applicable to 2 mm x 1.6 mm and 2 mm x 3 mm optical
cables.
Issue 02 (2023-05-22)
Copyright © Huawei Technologies Co., Ltd.
4 Processing the Optical Fiber
12
Advertisement
Table of Contents
