FTK01 & FMC2105-SU
FTTR Fiber Termination Kit & Field Mountable Connector
Quick Installation Guide
1. Stripping a 1.2 mm x 1.6 mm transparent optical cable: Use diagonal pliers to cut the sheath in the
2. If no bare fiber is exposed after the sheath is removed, bend the sheath at the initial stripping point
Step 3 Cut off the extra sheath of the optical fiber and ensure that the end faces of the sheath on both
sides are flush.
Do not use the tip of the diagonal pliers to cut the sheath. Otherwise, the optical fiber may be
damaged.
----End
Issue 02 (2023-05-22)
middle and, split the sheath by hand, and then cut off the sheath. Do not use the 2 mm x 1.6 mm
optical cable stripper in the FTK01 to strip the sheath.
by about 180 degrees until the optical fiber is broken and the bare fiber is exposed, as shown in the
following figure.
Copyright © Huawei Technologies Co., Ltd.
3 Stripping the Optical Cable
7