Table of Contents
Advertisement
2.3.
Connection - video-interface and CAN-box
The CAN-bus box reads digital signals from the CAN-bus and converts them for the video-
interface. ACC +12V max. 0.5A (red of 6pin) and reverse gear +12V max. 0.5A (green of 6pin)
constant signal. Video-source switching (white of 6pin) as +12V impulse.
Connect theblack female 4pin connector of the 20pin PNP harness to the male 4pin
connector of the CAN-box.
Connect the white female 6pin connector of the 6pin to 8pin cable to the male 6pin
connector of the video-interface.
Connect the black female 8pin connector of the 6pin to 8pin cable to the male 8pin
connector of the CAN-box.
Connect the CAN communication cable's white female 8pin connector to the 8pin
connector of the video interface.
Connect the separate white cable to the MMI signal at pin10 of the Quadlock for
alternative switching of sources by NAV button in the centre console, if existing.
(Only for MMI 3G, not for MMI 3G+ or RNS850)
Version 06.03.2020
HW CAM(V31),(V22)
RL2-MMI3G-Q3/GW
Advertisement
Table of Contents
