Table of Contents
Advertisement
Figure 101
5.
Rotate the radiator to access the filter; refer to
Accessing the Engine from the Right side (page
49)
6.
Replace the hydraulic filter as shown in
102.
Figure 102
7.
Add the specified hydraulic fluid into the fill tube
until you can see that the fluid level is between
the 2 marks the dipstick
Important:
Do not fill the hydraulic tank
with hydraulic fluid above the upper mark in
the dipstick.
8.
Start the engine, cycle the steering wheel and
deck-lift cylinders, and check for fluid leaks.
Allow the engine to run for about 5 minutes, then
shut it off.
9.
After 2 minutes, check the level of the hydraulic
fluid; refer to
Checking the Hydraulic-Fluid Level
(page
70).
g236164
Figure
g215918
(Figure
99).
Mower Deck
Maintenance
Rotating the Mower Deck
into the Maintenance
Position
1.
Park the machine on a level surface.
2.
Disengage the PTO, lower the mower deck, and
engage the parking brake.
3.
Raise the hopper and engage the magnetic
safety locks; refer to
Raised Position (page
4.
Unlatch and remove the grass chute; refer to
Clearing the Grass Chute (page
5.
Pull and rotate the rear link pins on both sides of
the mower deck.
6.
Raise the mower deck.
7.
Shut off the engine and remove the key.
8.
Using the handle and foot peg on the left side of
the mower deck, rotate the front of the mower
deck upward to the maintenance position.
Rotating the Mower Deck
into the Mowing Position
Important:
Ensure that you remove the
grass chute before performing this procedure;
otherwise, damage may occur.
1.
Park the machine on a level surface.
2.
Lower the mower deck.
3.
Rotate the rear link pins to release them into the
rear links.
4.
Insert the grass chute, rotate the operator's
seat, and lower the hopper.
71
Securing the Hopper in the
42).
32).
Advertisement
Table of Contents
