Table of Contents
Advertisement
Figure 123
1. Jam nut
2. Socket-head bolt
B.
Loosen the jam nut that secures the
socket-head bolt
C.
Adjust the wing blade height for the right
side of the deck as follows:
•
Rotate the socket-head bolt clockwise to
lower the right side of the mower deck.
•
Turn the socket-head bolt
counterclockwise to raise the right
side of the mower deck.
8.
Measure the outermost point of the blade cutting
edges
(Figure
122).
9.
Repeat steps
7
and
between the measurements is 3.2 mm (1/8 inch)
or less.
10.
Tighten the 2 nuts for the leveling link and the
jam nut for the socket-head bolt
Leveling the Mower Deck Front to
Back
1.
Adjust the height of cut to the 75 mm (3 inches)
position
(Figure
124).
3. Nuts (leveling link)
(Figure
123).
8
until the difference
(Figure
123).
g231919
1. Height-of-cut indicator (75 mm position)
2.
Shut off the engine and remove the key.
3.
Align a wing blade to the forward-most position
(Figure
125).
1. Right wing blades
2. Front of the machine
4.
Measure the distance between the ground and
the forward-most point of the blade cutting edge
with a gauge block
Record the left blade
measurement here:
Record the right
blade measurement
here:
80
Figure 124
Figure 125
3. Left wing blades
(Figure
126).
g231943
g232024
g231946
Advertisement
Table of Contents
