Table of Contents
Advertisement
Throttle Lever
Use the throttle lever
(Figure
speed. Moving the throttle lever forward toward the
F
position increases the engine speed. Moving
AST
the throttle lever rearward toward the S
decreases the engine speed. The throttle lever
controls the speed of the blades and, with the traction
pedal, controls the ground speed of the machine.
Hour Meter/Service Due Indicator
The hour meter
(Figure
accumulated hours of engine operation.
The service due indicator displays the number of
hours until the next engine oil and filter change.
Note:
The indicator flashes automatically with "OIL
CHANGE" when you need to change the engine oil
and filter.
The service due indicator also displays the number of
hours until you need to grease the machine.
Note:
The indicator flashes automatically with
"LUBE" when you need to lubricate the machine.
Push the button O
the hour meter/service due
N
indicator to select the function on the screen.
Important:
During the first 50 hours while in the
oil change mode, take care to not inadvertently
hold the button of the hour meter longer than
6-seconds. Holding the button longer than
6-seconds will set the oil service interval from 50
hours to 250 hours.
After changing the engine oil and filter or lubricating
the machine and mower deck, perform the following:
1.
Push the button until you reach the desired
screen.
2.
Push and hold the button for 6 seconds until the
indicator stops flashing.
Note:
You cannot reset the total working hours of
the machine.
Deck Lift Lever
Pull the lock collar on the deck lift lever
and move the lever rearward to raise the mower deck.
Pull the lock collar on the deck lift lever
up and move the lever forward to lower the deck and
allow it to float.
Important:
To avoid damaging the deck-lift
system, set the deck lift lever to the forward
(
) position whenever you drive the machine
FLOAT
with the deck on the ground.
Note:
Lower the deck and hopper whenever you are
not using the machine.
8) to control the engine
position
LOW
8) records and displays
(Figure
(Figure
1. Hopper dump lever
2. Hopper lift lever
Hopper Lift Lever
Pull the lock collar on the hopper lift lever
up and move the lever rearward to raise the hopper.
Pull the lock collar on the hopper lift lever up and
move the lever forward to lower the hopper.
Hopper Dump Lever
Pull the lock collar on the hopper dump lever
10) up and move the lever rearward to dump the
clippings from the hopper.
Pull the lock collar on the hopper dump lever up and
move the lever forward to close the hopper after
dumping.
Key Switch
The key switch has 4 positions: O
O
/P
N
REHEAT
Note:
The L
When you turn the key switch from the O
10) up
the L
O
IGHTS
When you turn key switch from the O
10)
position to the L
continues to run and light illuminates.
Note:
If the engine stops running and the key switch
is in the L
IGHTS
you leave the operator's seat, after a short delay a
buzzer will sound to alert you to turn the key to the
O
position.
FF
18
Figure 10
3. Deck lift lever
FF
, and S
.
TART
O
position controls the work light.
IGHTS
N
position, the light illuminates.
N
O
position, the engine
IGHTS
N
O
or the O
/P
N
N
REHEAT
g213965
(Figure
10)
(Figure
, L
O
,
IGHTS
N
position to
FF
/P
N
REHEAT
position, and
Advertisement
Table of Contents
