Toro 31051 Operator's Manual page 16

Oil-Pressure Warning Indicator
The oil-pressure warning indicator
illuminates if the engine-oil pressure drops below
a safe level while the engine is running. If the light
flickers or remains on, stop the machine, shut off the
engine, and check the oil level. If the oil level is within
the acceptable range, but the light does not go out as
the engine runs, shut off the engine immediately and
contact your authorized Toro distributor for assistance.
Check the operation of warning light as follows:
1. Engage the parking brake.
2. Turn the key switch to the O
but do not start the engine.
Note:
The oil-pressure light should glow red.
If the light does not function, either a bulb is
burned out or there is a malfunction in the
system which must be repaired.
Air-Filter Restriction Indicator
The air-filter restriction indicator
if the air filter needs to be cleaned or replaced; refer to
Servicing the Air-Cleaner Filters (page
Work-Light Indicator
The work-light indicator
work light is on.
Road-Lights Indicator
The road-lights indicator
road lights are on.
Raised-Hopper Indicator
The raised-hopper indicator
the hopper raises from the grass-collecting position.
Lower the hopper to turn the indicator off.
Parking-Brake Indicator
The parking-brake indicator
the parking brake is engaged.
(Figure 6)
/P position,
N REHEAT
(Figure 6) illuminates
50).
(Figure 6) illuminates if the
(Figure 6) illuminates if the
(Figure 6) illuminates if
(Figure 6) illuminates if
PTO Switch
The PTO switch (Figure
(engaged) and I (disengaged). Pull out the PTO
N
switch to engage the implement or mower-deck
blades. Push in the button to disengage the implement
operation.
Note:
If you leave the operator's seat while the PTO
switch is in the O position, the machine automatically
N
shuts off the engine after a 1-second delay; refer to
Resetting the PTO Function (page
Hazard-Lights Switch
Push the hazard-lights switch
turn the hazard lights on.
Push the switch rearward to turn the hazard lights off.
Differential-Lock Switch
Push the differential-lock switch
engage the differential lock.
Push the switch rearward to disengage the differential
lock.
Radiator Fan-Reversal Switch
Push the fan-reversal switch
engage the fan-reversal cycle for the radiator.
Beacon-Light Switch
Push the beacon-light switch
turn the beacon light on.
Push the switch rearward to turn the beacon light off.
Turn Signal/Road
Lights/Work-Light Lever
Rotate the lever (Figure
turn the work light on.
Rotate the lever forward to the second slot to turn the
road lights on.
Rotate the lever rearward to turn the lights off.
Push the lever forward to turn on the right-turn signal.
Pull the lever back to turn on the left-turn signal.
16
6) has 2 positions: O
UT
34).
(Figure 6) forward to
(Figure 6) forward to
(Figure 6) forward to
(Figure 6) forward to
6) forward to the first slot to