Strap Joint Formation & Appearance - Signode SCMH-58 Operation, Parts And Safety Manual

OPERATING INSTRUCTIONS, Continued
6. REMOVING THE TOOL. Hold the cut-off end of
the top strap with the left hand and squeeze the
feedwheel support handle and the sealer handle
together with the right hand. Swing the rear end
of the tool to the right to remove it from the
tensioned tie. The strapping cycle is now
complete. Inspect the strap joint for proper
formation by reviewing Joint Appearance and
Formation below.
STRAP JOINT APPEARANCE & FORMATION
A properly formed joint will appear as shown in the following illustration.
If the joint does not appear as shown, then the operator must proceed as follows:
! Make sure that the tool's operating instructions are being followed before applying
another strap.
!
Make sure that tension has been applied to the straps before the sealer handle has
been actuated. Tension is necessary to ensure that the keys fully interlock.
After confirming the above, cut off the strap and apply another.
If the joint still does not appear as shown, then inspect the tool for worn and/or damaged parts.
Replace tool parts as needed.
NEVER HANDLE OR SHIP ANY LOAD WITH IMPROPERLY FORMED JOINTS.
Misformed joints may not secure the load and could cause serious injury.
8