Signode SCMH-58 Operation, Parts And Safety Manual page 7

4. APPLYING TENSION. While standing to one side
of the strap line, grasp the tension handle with
the right hand and the sealer handle with the left
hand. Move the tension handle forward and back
between the 11 o'clock and 2 o'clock positions
repeatedly, until the strap is tensioned around
the package.
NOTE: When applying high tension on uneven
package it may be helpful to maintain strap
alignment by guiding the tool as shown.
Never squeeze the feedwheel support handle and sealer handle together while
tensioning strap.
5. SEALING THE STRAPS. After the strap has been tensioned, grasp the sealer handle with the
left hand. Move the sealer handle fully forward while pulling back on the tension handle to
punch completely through both layers of strap.
NOTE: If the sealer handle is not cycled fully forward the strap will not be completely punched
or cut off. If this occurs the tool cannot be removed from the tensioned strap. To remove the
tool cycle the sealer handle completely forward a second time. If the tool still fails to
completely cut or punch the straps, cut the straps and tool from the package. Check the tool
for worn or broken parts. Inspect the strap joint for proper formation of interlocking keys.
7