Display Pss Error Stack - Pilz PSS WIN-PRO Getting Started

Please note the following when displaying variables:
• You can enter a maximum of 32 operands/addresses in the variable
table.
• Before you enter data words in the variable table, you must always state
the corresponding data block, e.g. "DB053" in the Operand column.

Display PSS error stack

The error stack of each PSS can be displayed.
Fig. 5-5: Error stack
1. Connect computer
2. Display error stack
3. Display remedy
PSS WIN-PRO Service Version: Getting Started
Connect your computer to the PSS (see also "Connect computer to
PSS").
Select PSS -> Display Error Stack .
The PSS error messages are shown in the information window under
the Error Stack tab. The display is constantly updated. Displaying the
error stack places quite a load on PSS WIN-PRO. For this reason it
makes sense to exit the error stack display when you are finished.
To display the remedy for a particular error, double-click on the rele-
vant error entry.
The remedy describes how to react to the event/error. The remedy
contains a maximum of 8 steps, the so-called "Actions". These actions
should be performed in the order stated. If the first action does not
rectify the error, carry out the next action, etc. If any action does not
apply to your application, simply miss it out.
5-13