Pilz PSS WIN-PRO Getting Started page 22

Functions
1. Connect computer
2. Open project or PSS program
3. Set the mode
4. Select block
5. Start dynamic program display
5-8
Connect your computer to the PSS (see also "Connect computer to
PSS").
You can view the PSS program and then start dynamic program
display for a block, or you can open the project that contains the
identical program to that of the PSS and start dynamic program display
for a block. The benefit of the latter is that you can display the tags and
comments from the allocation table.
Open a project ( Project -> Open ) or select PSS -> Open PSS Pro-
gram .
Switch to FS mode if you wish to run dynamic program display on an
FS block or ST mode if you wish to run dynamic program display on an
ST block.
You can display the Program Manager tab in the project window and
from there select the block whose contents you wish to view, or you
can display the Program Structure tab and select the block there. If all
the blocks in the program are called just once, you can use either
method. If a block is called several times within the program, you can
only select the block calls you wish to display via the program
structure.
In the Project Manager or in the Program Structure, double-click on the
block whose contents you wish to view.
Select PSS -> Dynamic Program Display -> Start dynamic program
display across one segment or PSS -> Dynamic Program Display
-> Start dynamic program display across several segments .
The block is opened and dynamic program display is run.
PSS WIN-PRO Service Version: Getting Started