Decommissioning; Residual - MAXA i-290 0106 Installer Manual

Weight [kg]
Component
Compressor
Plate heat exchanger
Cu-Al heat exchanger battery
Liquid receiver
Liquid separator
Circulator
Deaerator
Fan
Compressor Driver
Electric filter
Inductance
10.

DECOMMISSIONING

Once the unit has reached the end of its life cycle and needs to be replaced, the following operations are recommended:
• The refrigerant has to be recovered by trained personnel and sent to proper collection centres; according to the procedures indicated in
Regulation No. 517/2014 on fluorinated greenhouse gases;
• Any antifreeze additives in the water circuit must be recovered and disposed of properly;
• The compressors' lubricating oil has to be collected and sent to proper collection centres;
• The electronic components, such as regulators, driver boards and inverters, must be disassembled and sent to proper collection centres;
• The structure and the different components, if unusable, must be scrapped and divided according to their nature; there is especially a good
amount of copper and aluminium in the machine.
These operations allow easy material recovery and the recycling process, thus reducing the environmental impact in accordance with the provi-
sions of Directive 2012/19 / EU on waste electrical and electronic equipment (RAEE).
The user is responsible for the proper disposal of this product, according to national regulations in the country of destination of the appliance.
For more information, you should contact the Installation Company or local competent authority.
An incorrect decommissioning of the appliance may create serious environmental damage and endanger people's safety.
Therefore, it is recommended that the unit be disposed only by authorised persons with technical training who have attend-
ed training courses acknowledged by the competent authorities.
It is required to follow the same precautions described in the previous paragraphs.
Pay special attention during disposal of the refrigerant gas.
The illegal disposal of the product by the end user leads to the application of the penalties in accordance with the law in the
country where the disposal takes place.
The crossed-out bin symbol applied on the appliance indicates that the product, at the end of its useful life, must be collect-
ed separately from other solid/municipal waste.
The units are manufactured in accordance with the EC directive on waste of electric/electronic equipment and the harmful
effects of incorrect disposal are provided in the user/installer manual. The manufacturing company or its importer/retailer is
available to respond to any requests for additional information.
11.

RESIDUAL

The residual risks related to handling, installation and normal operation of the unit are listed below. Any failure by the user and installer to
comply with the instructions/indications in the manual (references to which are given in the table) will result in the continuation of these risks,
which cannot be eliminated by the manufacturer, who has already taken all the necessary design precautions to ensure that each risk is reduced
to a minimum.
0106 0109
13,7 13,8
4,8 7,0
6,9 10,7
- -
- -
1,7 1,7
1,7 1,7
4,5 4,5
2,0 2,0
0,5 0,5
1,4 1,4
i-290
Inverter air/water heat pumps with axial fans
Unit model
0112 0115
25,7 25,5
7,0 7,0
14,3 22,0
0,6 0,8
- -
3,5 3,5
2,2 2,2
4,5 4,5
2,5 2,5
1,5 1,5
3,7 3,7
0118
25,5
7,0
22,0
0,8
-
3,5
2,2
4,5
2,5
1,5
3,7
45