Table of Contents
Advertisement
Installation Manual
H3C XE 200/2000 IP PBX
Step 2: Press the ejector button next the memory card. The ejector button moves
outwards and the memory card projects from the panel.
Figure 5-6 Remove memory card
Step 3: Pull the memory card out of its slot with hands at its nonconductive edges. Store
the removed memory card in an antistatic bag to avoid possible damages.
Caution:
You can only hold the memory card by its nonconductive edges, since the memory
card is sensitive to ESD damage, which may occur if you handle the card
improperly.
It is OK if you feel hard when removing the memory card. Do not operate too fiercely
in this process.
Never touch the surface components of the memory card with your hands.
The DDR SDRAM1 and DDR SDRAM2 in Figure 5-5 do not work as basic memory
and extended memory. They are numbered just in purpose for distinguishing them.
III. Inserting memory
Step 1: Check the right position of memory on the mainboard.
Step 2: Insert the memory card into the right slot.
Step 3: Press the memory card until it is fully seated. The ejector button remains flush
with the panel.
Repeat the above steps to install other memory cards.
5.3.4 Closing Chassis
Please refer to section 5.3.2 "Opening the Chassis" on page 5-11.
5-14
Chapter 5 System Maintenance
Advertisement
Table of Contents
