Table of Contents
Advertisement
Configuration
(Standalone)
Automatic Mode
Sound-Active
Mode
Pan Orientation
Tilt Orientation
Display
Orientation
Manual Pan
Range
Manual Tilt Range
Temperature
Reset
Load Factory
Defaults
Intimidator Spot 155 User Manual Rev. 1
Set the product in one of the standalone modes to control without a DMX controller.
·
Connect the product to power.
Never connect a product that is operating in any standalone mode (either
Automatic or Sound-Active) to a DMX string connected to a DMX controller.
Products in standalone mode may transmit DMX signals that could interfere with
the DMX signals from the controller.
To enable the Automatic mode, do the following:
1.
Press <MENU> repeatedly until SLAV, NASL, NAFA, or NStS shows on the
display.
2.
Use <UP> or <DOWN> to choose either:
·
NASL (for a slow program)
or
·
NAFA (for a fast program)
3.
Press <ENTER>.
To enable the Sound-Active mode, follow the instructions below:
1.
Press <MENU> repeatedly until SLAV, NASL, NAFA, or NStS shows on the
display.
2.
Use <UP> or <DOWN> to choose NStS.
3.
Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
To select the pan orientation on the Intimidator Spot 155, do the following.
1.
Press <MENU> repeatedly until PAn or rPAn shows on the display.
2.
Use <UP> or <DOWN> to select between normal pan operation (PAn) and inverse
pan operation (rPAn).
3.
Press <ENTER>.
To select the tilt orientation on the Intimidator Spot 155, follow the instructions below.
1.
Press <MENU> repeatedly until tiL or rtiL shows on the display.
2.
Use <UP> or <DOWN> to select between normal tilt operation (tiL) and inverse tilt
operation (rtiL).
3.
Press <ENTER>.
To select the display orientation on the Intimidator Spot 155, do the following:
1.
Press <MENU> repeatedly until diS or rdiS shows on the display.
2.
Use <UP> or <DOWN> to select between normal display orientation (diS) and
inverse display orientation (rdiS).
3.
Press <ENTER>.
To set the pan range, follow the instructions below.
1.
Press <MENU> repeatedly until PA54, PA36 or PA18 shows on the display.
2.
Use <UP> or <DOWN> to select between 540° (PA54), 360° (PA36), or 180°
(PA18).
3.
Press <ENTER>.
To set the tilt range, do the following.
1.
Press <MENU> repeatedly until ti27, ti18 or ti 9 shows on the display.
2.
Use <UP> or <DOWN> to select between 270° (ti27), 180° (ti18), or 90° (ti 9).
3.
Press <ENTER>.
To view the current temperature of the Intimidator Spot 155, follow the instructions
below:
1.
Press <MENU> repeatedly until t _ _ shows on the display.
To reset the fixture, do the following.
1.
Press <MENU> repeatedly until rESt shows on the display.
2.
Press <ENTER>.
To load the factory defaults, do the following.
1.
Press <MENU> repeatedly until LOAd shows on the display.
2.
Press <ENTER>.
Page 13 of 18
Advertisement
Table of Contents
