Table of Contents
Advertisement
E. Maintenance Alarm / Operation Cycles Count Setting
a) Press and hold the SET Button until "1" appears on the display, then
release the button.
b) Press the UP button until "E" shows on the display.
c) Press SET to enter this setting sub-menu. You're now in the
maintenance alarm / operation cycles count setting adjustment mode. A
"0" will be shown on the display.
d) Press the UP or DOWN button to adjust the maintenance alarm /
operation cycles setting between "0" and "5" on the display. "0" is the
factory setting.
"0" means the maintenance alarm / operation cycles setting is
off.
"1" means that once the opener has operated 1000 times
(1000 cycles), then the LED will flash 10 times every time the
door is opened or closed and the letter "t" will also be shown
on the display.
Each setting between 1 and 5 is that number x one thousand
and represents the number of cycles for the maintenance
alarm / operation cycles setting.
e) Press SET to confirm your selection. The display will return to "I I".
NOTE:
1. Should a "b" appear on the display in combination with the LED
flashing 10 times, this is an indication that the garage door has
lost its balance and contacting a garage door specialist to
have your door inspected for safety is necessary.
2. Clearing the maintenance alarm / operation cycles setting can be
done by pressing the SET button.
54
Advertisement
Table of Contents
