Table of Contents
Advertisement
Increase
Decrease
Increase time
Decrease time
5. Automatic Closing-Condition Setting
a) Press and hold the SET Button until "1" appears on the
display, then release the button.
b) Press the UP button until "5" shows on the display.
c) Press SET to enter this setting sub-menu. You're now in the
auto-close condition adjustment mode. A "1" will be shown
on the display.
d) Press the UP or DOWN button to select the auto close
condition. The options are "1" or "2":
"1" means that the auto-close function will only operate
when the door is in the completely open position.
"2" means that the auto-close function will operate
when the door is in any position.
e) Press SET to confirm your selection. The display will
return to "I I".
NOTE:
1. The factory setting for this sub-setting is "1".
2. The auto-close will not resume closing if the auto-close is
stopped during its process.
6. LED
a) Press and hold the SET Button until "1" appears on the display,
then release the button.
b) Press the UP button until "6" shows on the display.
c) Press SET to enter this setting sub-menu. You're now in the LED
light delay adjustment mode. A "3" will be shown on the display.
d) Press the UP or DOWN button to increase or decrease the desired
time . The setting can be set between "1" and "9" on the display.
"3" is the factory setting which means the LED will remain on for
3 minutes after opening/closing.
Each number between 1 and 9 is the number shown on
the display x 1 minute, and this is the delay of the LED
light.
e) Press SET to confirm your selection. The display will return to "I I".
49
Advertisement
Table of Contents
