Table of Contents
Advertisement
Programming Instructions
1.
Programming Opening and Closing Limits
a) Press and hold the SET button until "1" appears on the display, then
release the button.
b) Press the SET button again. The opener is now in the end position
learning mode. An "n" with a dot in the corner will now be shown on
the display.
c) Press and hold the UP button until the door reaches the desired open
position. NOTE: Both the desired opening and closing positions can be
finely adjusted by pressing the UP or DOWN buttons again.
d) Press SET button to confirm the open position. A "u" with a dot in the
corner will now be shown on the display.
e) Now press and hold the DOWN button until the door reaches the
desired closed position.
f) Now press the SET button to confirm the closed position. The opener
will now cycle through the opening and closing positions to set the
travel limits and sensitivity settings. The display will flash "u" and "n",
respectively. When the opener has finished learning the taught in
positions, the display will show "I I".
CAUTION: After the opener cycles through the opening and closing
positions, a number (0~9) will be shown on the display. "0" means the
door is balanced and the opener has no trouble opening and closing
the door. The higher the number, the more unbalanced the door.
Should this number be higher than 5, then you should contact a
garage door specialist immediately and have your garage door system
inspected for safety and function.
1.1 Programming Remote Controls
NOTE: The remote controls that are supplied with the garage
door opener should be pre-programmed. If not, please follow
directions below.
a) Press the CODE button on the opener. A dot (.) will be indicated in
the corner of the display.
b) Now press and release the button on the remote you want to
use, wait 2 seconds, then press and hold the same button for 2
seconds.
The dot (.) on the display will flash to confirm the code,
then turn off and return the 2 short stripes. Repeat the process
for additional remotes that need to be stored.
1.2. Deleting Stored Remote Controls
Press and hold the CODE button until a "C" is indicated
on the display. All stored remotes will be deleted.
46
Advertisement
Table of Contents
