Description Of The Remote Control Keys; Follow Me Function; Turbo Function; Self Clean Function - Olimpia splendid ARYAL S1 E 10 C Instructions For Use And Maintenance Manual

The remote control display is illustrated just for greater clarity.
3.4.2 - Description of the remote control keys (figure 34)
1. MODE SELECTION key
Every time this key is pressed, a mode is selected in sequence,
AUTO > COOL DRY > HEAT > FAN and then back to AUTO.
2. ON/OFF key
Press this key to start the appliance and press it again to stop the appliance.
3. SWING/DIRECT key
Press the SWING key to activate/deactivate operation of the vertical openings.
Press the DIRECT key to activate/deactivate operation of the horizontal openings (not available for this
model).
4. TEMP/TIME key
Press the key to increase the indoor temperature set or to adjust the TIMER in a clockwise direction.
Press the key to lower the indoor temperature set or to adjust the TIMER in an anti-clockwise direction.
5. FAN key
Used to select fan speed, it has four levels AUTO, LOW, MED or HIGH.
The fan speed changes every time this key is pressed.
6. TURBO/SELF CLEAN key
Press the left part of this key to activate the TURBO function.
Press the right part of this key to activate the SELF CLEAN function.
10.SLEEP/FRESH key
Press the key (10) to activate/deactivate the SLEEP function.
11.LED/FOLLOW ME key
Press the left part of this key to activate/deactivate the internal display.
Press the right part of this key to start the FOLLOW ME function.

3.4.3 - Follow Me function

The remote control acts as a remote thermostat, allowing correct control of the temperature in its position.
• To activate the Follow Me function, point the remote control towards the unit and press the "Follow Me"
button.
The remote control displays the real temperature in its own position and sends this signal to the air
conditioner every 3 minutes, until the button is pressed again.
If the unit does not receive the Follow Me signal for 7 minutes, it emits a "beep", which signals that the
Follow Me mode has ended.
The Follow Me function is not available in the DRY and FAN mode.
• If the operating mode is pressed, or the unit is switched off, the Follow Me function is annulled automatically.

3.4.4 - TURBO function

• In TURBO mode, the fan motor functions at a very high speed in a way to reach the temperature set in
the least time possible.

3.4.5 - SELF CLEAN function

• In SELF CLEAN mode, the air conditioner automatically cleans and dries the evaporator and keeps it
fresh for successive use.
The function is used on switch off of cooling mode to clean the evaporator and keep it fresh for successive
use.
This function is easy to activate and accessible from the remote control.
EN - 22