Table of Contents
Advertisement
4. Attach the Front Leg (4) to the Frame (3) with
two M8 x 45mm Bolts (28), two M8 Washers
(29), and two M8 Locknuts (34). Make sure that
the Locknuts are in the indicated hexagonal
holes (C); do not tighten the Bolts yet.
5. Attach the Frame (3) to the Crossbar (2) with
two M8 x 70mm Bolts (27) and two M8 Locknuts
(34); do not tighten the Locknuts yet.
6. Insert the Backrest Support (14) into one of the
three sets of holes in the Uprights (1). Rotate
the Backrest Support so that the locking pin
(D) is wrapped around the Upright (see the
inset drawing).
See steps 2, 4, and 5. Tighten the M8 Locknuts
(34) used in these steps.
4
29
28
C
4
5
6
14
D
D
9
3
34
27
2
3
34
1
1
Advertisement
Table of Contents
