Table of Contents
Advertisement
10. Orient the Backrest (8) so that the slightly wider
end (E) is in the indicated location.
Orient the Backrest Tubes (7) so that the
indicated holes (F) are in the position shown.
Attach the Backrest Tubes (7) to the Backrest (8)
with four M6 x 40mm Screws (32) and four M6
Washers (22); do not tighten the Screws yet.
11. Apply grease to an M10 x 135mm Bolt (23).
Attach the Backrest Tubes (7) to the welded tube
(G) on the Frame (3) with the M10 x 135mm
Bolt (23), two M10 Washers (30), and an M10
Locknut (31). Do not overtighten the Locknut;
the Backrest Tubes must pivot easily.
See step 10. Tighten the M6 x 40mm
Screws (32).
10
8
E
F
32
11
31
30
7
3
G
11
7
22
32
22
30
23
Grease
Advertisement
Table of Contents
