Maintenance And Troubleshooting - ICON PRO-FORM 6.0 RT User Manual

MAINTENANCE AND TROUBLESHOOTING

Most treadmill problems can be solved by follow-
ing the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assis-
tance is needed, see the front cover of this manual.
SYMPTOM: The power does not turn on
a. Follow all surge supressor and grounding instruc-
tions on page 14. Make sure that the power cord is
plugged in as specifi ed.
b. After the power cord has been plugged in, make
sure that the key is inserted into the console.
c. Check the power
switch located on
the treadmill frame
near the power cord.
If the switch is in the
Off position, it has
tripped. To reset the
power switch, wait for fi ve minutes and then press
it to the Reset position.
d. If the symptom persists, remove the key from the
console and UNPLUG THE POWER CORD. Wait
two minutes, and then remove the fi ve #8 x 3/4"
Screws (4). Carefully pivot off the Motor Hood
(48). Make sure that all wires are fully connected.
Reattach the Motor Hood, plug in the power cord,
and return the key to the console.
d
4
c
Off
4
48
4
SYMPTOM: The power turns off during use
a. Check the power switch (see drawing c at the left).
If the switch has tripped, wait for fi ve minutes and
then press the switch back in.
b. Make sure that the power cord is plugged in. If the
power cord is plugged in, unplug it, wait for fi ve
minutes, and then plug it back in.
c. Remove the key from the console, and then
reinsert it.
d. If the treadmill still will not run, please see the front
cover of this manual.
SYMPTOM: The console displays remain lit when
you remove the key from the console
a. The console features a display demo mode,
designed to be used if the treadmill is displayed in
a store. If the displays remain lit when you remove
the key, the demo mode is turned on. To turn off
the demo mode, hold down the Stop button for a
few seconds. If the displays are still lit, see THE
INFORMATION MODE on page 19 to turn off
the demo mode.
SYMPTOM: The incline of the treadmill does not
change correctly
a. Hold down the Stop button and the Speed increase
button, insert the key into the console, and then
release the Stop button and the Speed increase
button. Next, press the Stop button and then
press the Incline increase or decrease button. The
treadmill will automatically rise to the maximum
incline level and then return to the minimum level.
This will recalibrate the incline system. If the incline
system does not begin calibrating, press the Stop
button again, and then press the Incline increase
or decrease button again. When the incline system
ais calibrated, remove the key from the console.
21