Kanomax 200 Series User Manual page 7

Removing the Battery Pack
• Remove the battery cover from the monitor.
• Insert your thumb under the top left hand side of the battery
pack and carefully lever the battery pack out from the retain-
ing clips.
• Unclip the connector from the monitor.
• Replace the battery cover.
Rechargeable Batteries
The optional Ni-MH (Nickel Metal Hydride) battery pack is used to
power the monitor as a portable unit. Please read the following infor-
mation carefully before using the battery pack to operate the Aero-
qual monitor.
Safety
•
Do not use the battery pack for any other purpose than oper-
ating the Aeroqual monitor
•
Do not disassemble or mutilate the batteries as this may
cause burns
•
Do not incinerate or heat as this may cause burns, the batter-
ies may burst or cause the release of toxic materials
•
Do not short circuit as this may cause burns
•
Use only batteries approved by Aeroqual and recharge your
battery only with the AC/DC adaptors supplied by Aeroqual.
•
Never use any charger or battery that is damaged or worn
out.
•
Batteries must be recycled or disposed of properly. They
must not be disposed of in municipal waste.
•
Never charge a Ni-MH in a hermitically sealed container.
Using the battery pack
The life of the battery pack will be affected by the way it is handled.
Take good care of the battery pack and follow the guidelines sug-
gested in the following section.
netzerotools.com
netzerotools.com
6