Dnr500 Series Rear Panel - FLIR DNR516P16 Instruction Manual

5

DNR500 Series Rear Panel

1. Power input: Connect the included AC power cable.
2. On / Off switch: Turns the NVR on or off.
3. PoE Ports: Connect IP cameras. Integrated PoE (Power Over Ethernet) ports provide
power to cameras and video connection to NVR.
4. LAN: Connect a CAT 5 RJ45 Ethernet cable for local and remote connectivity.
5. MIC IN/OUT: RCA input and output for 2–way audio.
NOTE
Audio-enabled IP cameras (not included) are required to use audio recording. You cannot record
audio from the input (e.g. microphone) connected to the MIC IN port.
6. HDMI: Connect to an HDMI monitor or TV (not included) to view the system interface.
7. USB port(s): Connect a USB mouse (included) or USB thumb drive (not included) for
data backup or firmware updates.
8. eSATA: Connect a self-powered external eSATA HDD (not included) to extend the stor-
age capacity of the system or for data backup.
9. Alarm block: Connect alarm/sensor devices (not included).
10. VGA: Connect a VGA monitor (not included) to view the system interface.
11. VIDEO OUT: Video output (BNC) to connect the system to a secondary monitor.
12. RS232: Service only; not supported.
#LX400023; r. 2.0/23328/23328; en-US
8